BFT PHOBOS N BT Manuel d'installation télécharger pdf (Page 11)

1) SET TO MANUAL OPERATION -

Disengage the drive gear by using the

triangular key and turning clockwise.

2) SET THE CLOSE LIMIT - Push the gate to its fully closed position. Remove the screw

that holds the proximity sensor at the front end of the actuator. Slide it back so that the

back end of the sensor housing is 3-1/2” from the center of the drive carriage and re-

attach screw that secures sensor in place.

3) SET THE OPEN LIMIT - Push the gate to its

fully open position. Remove the screw that holds

the proximity sensor closest to the actuator body.

Slide it forward so that the back end of the sensor

housing is 3-1/2” from the center of the drive

carriage and re-attach screw that secures sensor

in place.

3-1/2”

4) RE-ENGAGE THE MANUAL RELEASE - Use triangular key and turn

counterclockwise to re-engage gears.

SETTING THE LIMITS

5) FINE-TUNING THE LIMITS – Once the actuator is connected to the controller, it

must be powered and the limits might have to be fine-tuned by sliding them to the

correct position.

3-1/2”

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

BFT PHOBOS N BT Manuel d'installation Page 11